Bemicro cv
9/9c/Top_view.PNG
BeMicro CV (Cyclone V) FPGA Evaluation Kit
The BeMicro CV Cyclone V E FPGA Development Board features an Altera 28-nm Cyclone V FPGA in the familiar BeMicro form factor. The Altera 5CEFA2F23C8N Cyclone V FPGA resident on the Be Micro CV features a hardened memory controller (HMC) that supports DDR2, DDR3 and LPDDR2. On the BeMicro CV the HMC is connected to a single 16-bit wide, 1Gb DDR3 SDRAM device (U1).
Board Highlights
The BeMicro CV board features the following major component blocks:
- One Cyclone V E FPGA (5CEFA2F23C8N) in a 484-pin FineLine BGA (FBGA)
- 25,000 LEs
- 9,434 adaptive logic modules (ALMs)
- 1,760 Kbit (Kb) M10K and 196 Kb MLAB memory
- 4 fractional phase locked loops (PLLs)
- 50 18x18-bit multipliers
- 1 Hard Memory Controller
- 224 general purpose input/output (GPIO)
- 1.1-V core voltage
- FPGA configuration circuitry
- Active Serial (AS) x1 configuration (EPCS16I8N)
- Embedded USB-BlasterTM II for use with the Quartus® II Programmer
- Separate JTAG configuration header
- Clocking circuitry
- 50 MHz 1.8V oscillator
- 24 MHz 2.5V oscillator
- Memory
- 1Gbit DDR3 SDRAM (8 Meg x 16 x 8 banks)
- 1K (128 x 8) Two-wire Serial EEPROM
- Micro SD card slot
- General user input / output
- 8 user LEDs
- 2 User Pushbuttons
- 3 User DIP switches
- Prototyping
- 2 Terasic 40 pin prototyping headers
- BeMicro SDK 80-pin card edge connector
- Power via USB or via user-provided 5V supply
Documentation
Example Designs
Examples Designs from Arrow Asia BeMicro CV Home Page
